TMPro

Kawasaki

Software module 196

Kawasaki GTR1400 bike ignition switch Asahi-Denso

Memory device is serial eeprom 93c56 SMD8 package. Expected file size is 256 bytes. Use JMA TPX2 – Errebi TX2 or CN2/CN5 or K-JMD or YS-01 transponder.

Written transponder is ready programmed to start bike.

IMPORTANT: This software can programs ONLY SIMPLE TRANSPONDER. Transponder must be placed on ignition switch then bike can start. Original handsfree key can be programmed only by Kawasaki diagnostic tool.

Vehicles equipped with this unit:
Kawasaki: GTR 1400
Software module 162

Kawasaki JetSki Ultra engine ECU with ID4D Memory device is serial eeprom 24c04 SMD8 package. Expected file size is 512 bytes.  Use JMA TPX2 – Errebi TX2 or CN2/CN5 or K-JMD or YS-01 transponder. Written transponder is ready programmed to start the vehicle.
 

Vehicles equipped with this unit:
Kawasaki:JetSki Ultra
Software module 157

Texas Crypto 4D-63, 4D-64, 6D-72 new chip.

This software can prepare JMA TPX2 or CN2/CN5 or K-JMD transponder to 3 types:
– Texas Crypto 4D-63 Ford/Mazda/Lincoln
– Texas Crypto 4D-64 Chrysler/Subaru/Jeep/Renault/Isuzu
– Texas Crypto 6D-72 Toyota G with password 36, 56, 96, 37, 57 and 97. For Toyota G preparation only CN2/CN5 or K-JMD is possible to be used.
Prepared transponder you can program to car using diagnostic OBD2 device.

Vehicles equipped with this unit:
Software module 68

Kawasaki bikes engine ECU Denso, Mitsubishi. Memory device is serial eeprom 93c66/93c86/24c02/24c04/24c64 8 pin SMD package. Expected file size is 256/512/2048/8192 bytes. Use JMA TPX2 – Errebi TX2 or CN2/CN5 or K-JMD or YS-01 transponder. Written transponder is ready programmed to start bike. Click here to see opened Kawasaki bikes engine ECU Denso.

Vehicles equipped with this unit:
Kawasaki: ZX-6R, ZX-10R, ZX-11R, ZX-12R, ZX-14, ZX-1000, Z-750S, Ninja, Z1000, Z800